Copyright © 2023 KVMGalore® - All rights reserved.
RCT-CS1915V: 14¾-inch deep, vented-surface, single-sided 2-post shelf
for mounting light- to medium-weight IT peripherals in a 19-inch IT equipment rack
• Compatible with any 2-post rack, 4-post rack and wall-mount rack
• Low cost
• Reinforcement flange runs the width of the shelf
• Built-in cable-management
• 19" EIA 310-D compliant
• High grade textured black powder-coat finish
• Made in the USA
• Limited lifetime warranty
19-15V cantilever shelf is designed for general-purpose front-mounting onto a 2-post rack, a 4-post rack or a wall-mount rack for single-sided mounting applications.
When mounted in 4-post racks, 19-15V cantilever shelf offers the flexibility of being mounted anywhere in the rack without using rear rack-space.
19-15V cantilever shelf is constructed of 18-gauge CRS (cold rolled steel) to keep the cost down, while supporting 25 lb of evenly distributed weight-load.
Rackit's 19-15V cantilever shelf is perfect for mounting light-weight non-rack mountable peripherals such as modems, wireless routers, KVM switches and LCD-screens onto a relay rack or a 4-post equipment rack.
Rackit's 19-15V cantilever shelf features a surface with a venting pattern that allows for maximum airflow. It is meticulously constructed with rounded corners, eliminating sharp edges which could potentially damage equipment, cabling, or installers' hands while handling.
Rackit's 19-15V cantilever shelf can facilitate cable-management with one oblong cut-out on each side mounting flange and two slits for a cable-tie on each side mounting flange.
Rackit's 19-15V cantilever shelf is compatible with any-type IT rack-mounting rails, fitted with either pre-tapped or cage-nut style mounting rails.
Made in the USA and offered with a lifetime warranty, Rackit's 19-15V cantilever shelf features a textured black powder coat finish that lends durability to the shelf, while helping to keep it free of scratches.
• Rack-mounting screws are not included - see listing below for screws that match the mounting holes on your rack