RCT-CMRR-24: 2-post, 24U cable-management-friendly steel telco racks 

with built-in grounding studs 

• Open top design supports large cable bundles
• 3-inch deep upright rails support large cable-runs
• Rails feature four ¼-20 grounding studs for electrical grounding
• Heavy-duty 14-gauge steel construction with 800 lbs. weight capacity

Comit relay racks' welded L-bracket base and cold rolled steel design form a sturdy construction for a rigid, durable rack. Comit relay racks can hold up to 800* lbs. of equipment, including switches, patch panels, shelves, rack-mount keyboard trays, and more.

Comit relay racks feature four ¼-20 x 0.5" grounding studs on the inside of the rails (two on each rail, one at the top and one at the bottom) used for electrical grounding. These studs allow you to ground your equipment directly to the stud or with the use of bus bars (purchased separately).

The racks also include serrated tooth washers to allow the frame to be grounded during the assembly process. The washers, when tightened, dig in and remove paint from the steel surface, establishing electrical continuity throughout the rack.

When multiple Comit relay racks are needed, simply gang them together. Ganging holes on both sides of the frame make it easy to gang and secure multiple racks together. You can even gang both the 24U and 45U size racks together because the holes align.

The uprights also feature cable pass through holes to allow cabling to pass from one rack to the next.

Comit relay racks' completely open top design allows the racks to accept cable bundles. It also makes the racks compatible with most ladder racks and coordinating accessories.

When you need a 2-post rack that offers both strength and dependability - whether working with a wiring closet, telecom room, or data center - Comit relay racks are the ideal racking solution.

Features and Benefits
• #10-32 pre-tapped mounting holes on front and back of upright rails
• Ganging holes support networking racks together
• Cable pass-through holes support cable runs in between ganged racks
• Ship knocked down (UPS-able)
• 19" EIA compliant
• Made in the USA
• Limited lifetime warranty

In the Box
2x 24U rails
2x L bases
2x upper support brackets
• Assembly hardware
• Floor-mounting hardware not included
• Equipment mounting screws not included - see listing below for compatible mounting screws

* To maintain its weight capacity, the rack must be bolted or secured to the floor. We always recommend installing your heaviest equipment at the lowest points on the rack.